website statistics



Since 2019, we have been supplying retro fit boom recirculation kits for a variety of PWM SP boom sprayers.




Distributed globally by Fantastic Nozzles


2020 BRS Spray Mode.png

The Arag Boom Recirculation System allows the boom to be plumbed in a single boom line recirculation configuration. This allows the flow to travel through the boom and back to the tank when not spraying.

  • Pressurise/prime spray line on way to job (PWM versions only),
    • That means instant ON, for an immediate fully dispersed spray pattern.
  • Flush boom lines to tank or to ground (safe disposal),
    • That gives you dual options for drainage and disposal.
  • Prevent particles settling in boom lines or tank,
    • Well, that's stating the obvious ;)
  • Hygienic contamination prevention.
    • This you can calculate precisely against the cost of the first few hectares of a damaged crop!

ARAG BRS is suited to all Individual Nozzle Control systems including JD Exact Apply and Case Patriot Aim Command.


Recirculation for JD and Patriot!

  • The systems are enabled by replacing the boom section end fittings with a specially engineered adapters allowing the connection of all of the sections into a single (common rail) line.
  • Switch between Spray and Recirculation modes with a single in cab switch. 
  • Flushing to ground (safe disposal), is done with a simple manual, ball valve.


Manual boom section flush for JD

Using the same stainless steel component to replace the JD aspirator as on the recirculation system, add elbow, T Fork fittings and ARAG flush valves.


2020 BRS Recirculation Mode.png


The ARAG Boom Recirculation System is is a very neat factory looking installation, with the best features being the simple ON/OFF (Spray or Recirculate) operation and that NO INTEGRATION is required with onboard electronics!

ARAG Boom Recirculation System.jpeg




 Articles | About | Contact