The Arag Boom Recirculation System allows the boom to be plumbed in a single boom line recirculation configuration. This allows the flow to travel through the boom and back to the tank when not spraying.

• Pressurise/prime spray line on way to job,
• That means instant ON, for an immediate fully dispersed spray pattern.
• Flush boom lines to tank or to ground (safe disposal),
• That gives you dual options for drainage and disposal.
• Prevent particles settling in boom lines or tank,
• Well, that's stating the obvious ;)
• Hygienic contamination prevention.
• This you can calculate precisely against the cost of the first few hectares of a damaged crop!

Arag BRS is suited to all Individual Nozzle Control systems, such as ARAG Seletron, ARAG Selejet and the JD Exact Apply system!

Recirculation for JD

• The system on JD is enabled by replacing the boom section end aspirators with a specially engineered fitting allowing the connection of all of the sections into a single (common rail) line.
• Switch between Spray and Recirculation modes with a single in cab switch. 
• Flushing to ground (safe disposal), is done with a simple manual, ball valve.

Manual boom section flush for JD

Using the same stainless steel component to replace the JD aspirator as on the recirculation system, add elbow, T Fork fittings and ARAG flush valves.

Questions on potential for mid-boom line Pressure Drop?

There has been a little banter on Twitter lately and we've received a few questions that we (ARAG & me) have answered this way;